Village
of Plover
R-3 Single-Family Residential District
|
R3
|
SINGLE-FAMILY RESIDENTIAL DISTRICT |
PURPOSE. The R-3 Single-family
Residential District is established to provide an additional choice
of density for single-family living having smaller lots. This District
is intended to be provided for all lands where sewer, and eventually
water, is or will be required. Other areas where this District could
be located should be consistent with land use standards and the
Village Comprehensive Plan.
PERMITTED USES.
(a) Any permitted use in the R-2 District.
(b) Customary accessory uses.
(c) (Am. Ord. #15-97) Signs as permitted in ch. 23 of this Code.
CONDITIONAL USES.
(a) Any conditional use in the R-2 District.
(b) Historical museums.
(c) Wind generators or windmill towers.
(d) (Cr. Ord. #16-97) Parking of commercial vehicles with a manufacturer's
weight rating of 8,000 pounds or more.
MINUMUM STANDARDS FOR THE R-3 DISTRICT.
(Cr. Ord. #5-85; Am. Ord. #24-91).
|
use
|
lot
area
|
lot
width
|
lot
area
per
family
|
height
of
structure
|
side
yard
|
street
setback
|
rear
yard
|
parking
|
signs
|
|
As
per-
mitted
users
|
15,000
Sq. ft.
|
80
Ft.
|
15,000
Sq. ft.
|
Not
over
35 Ft.
nor
over
2 1/2
stories
|
20
Ft.
total
of
both
sides.
1 side
not
less
than
8 ft.
for
building
not
over 2
1/2
stories
|
25
Ft.
from
both
streets
on
corner
lots
|
Not
less
than
20%
of
depth
of lot,
but
need
not
exceed
30 ft.
&
may not
be less
than
15 ft.
in
depth
|
Sec.
20.11
|
Per
Sign
ord.
|
|
Conditional
Uses
|
As
set by the Plan Commission and Village Board
|
Community Development Department
Plan Commission / Zoning Codes
Plan Commission Agenda / Plan
Commission Minutes
